The SimCoder Module is an add-on option to the PSIM software for automatic code generation.
SimCoder provides the capability to simulate a system in PSIM first, and then automatically generate C code from the PSIM schematic. Together with a specific hardware target, SimCoder can generate code that is ready to run on the specific hardware.
The automatic code generation provides a seamless integration between simulation and hardware implementation, and greatly speeds up the development and design process.

Below shows a screenshot of SimCoder with TI F28335 Hardware Target. The image shows a 2-ch DC/DC Buck Converter Kit (TMDSDCDC2KIT), and inside the F28335 DSP - Enlarged View

At the present, SimCoder supports these hardware targets: TI F28335 Target, PE-Pro/F28335 Target, PE-Expert3 Target and General Hardware Target.

With the TI-F28335 Target, the generated code can run directly on any boards that use Texas Instruments' floating-point DSP F28335.
View or download the TI F28335 Hardware Target Tutorial (pdf).

With the General Hardware Target, code can be generated for generic-type hardware. Users can make changes to the code and adopt the code for their own specific hardware.

With the PE/Pro-F28335 Target and PE-Expert3 Target, the generated code can run directly on PE-Pro/F28335 and PE-Expert3 DSP hardware made by Myway Co. (www.myway.co.jp). Note that these two Targets are available in certain countries only.

More hardware targets will be supported in the future. For more information on the SimCoder Module, please refer to the SimCoder User Manual.